English: Series-RC parallel termination: A series-RC parallel termination scheme uses a resistor and capacitor (i.e., series-RC) network as the terminating impedance. The terminating resistor (Rl) is equal to Zo. The capacitor must be large enough to filter the constant flow of DC current. However, if the capacitor is too large, it will delay the signal beyond the design threshold. Capacitors smaller than 100 pF diminish the effectiveness of termination. The capacitor blocks low-frequency signals while passing high-frequency signals. Therefore, the DC loading effect of Rl does not have an impact on the driver, as there is no DC path to ground. Not all drivers can handle the dynamic current requirements for larger capacitor loads.
1) This text is not part of my submission, only the figure itself is. Rewrite your own summary.
uvedenie autorov – Musíte spomenúť autorov (jednotlivo alebo kolektívne), poskytnúť odkaz na licenciu a uviesť, či ste niečo zmenili. Môžete to urobiť ľubovoľným primeraným spôsobom, ale nie spôsobom naznačujúcim, že poskytovateľ licencie podporuje vás alebo vaše použitie diela.
meniť za rovnakých podmienok – Ak toto dielo zmeníte, prevediete do inej formy alebo použijete ako základ iného diela, musíte výsledok šíriť pod rovnakou alebo kompatibilnou licenciou ako originál.
Tento súbor obsahuje ďalšie informácie, pravdepodobne pochádzajúce z digitálneho fotoaparátu či skenera, ktorý ho vytvoril alebo digitalizoval. Ak bol súbor zmenený, niektoré podrobnosti sa nemusia plne zhodovať so zmeneným súborom.